238 E Ironstone Dr, Meridian, ID 83646

PPE (Personal Protective Equipment) (This is safety equipment for our techs to wear during remediation practices. This is a per person per day basis. There will need to be new PPE every day for proper safety. This includes the Tyvek suits, gloves, and any filters per the duration of the job).

Pre and post HEPA vacuuming areas of growth in the crawlspace.(HEPA vacuuming is a process of pulling all contaminates off a surface area. This process eliminates mold particles from a surface area with specific vacuums without contaminating the air quality of a livable space. HEPA vacuuming is normally done before and after to reassure no particles are in the space that was contaminated).

Treatment with anti-microbial solution in crawlspace hit and miss in the crawlspace. (Treatment is performed with an anti-microbial solution that eliminates and prevents future growth. All treatment is warrantied for 3yrs. unless Boise Mold Removal does not provide a warranty under the stipulations of the client not solving the underlying issue that caused the growth in the first place.)

Contain area for remediation in the closet. (Containment eliminates any contaminates from existing into the livable space. Without the containment also the insulation, if removed can possibly enter the livable space, kicking insulation, dirt and possible mold-like substance around. We can pull the containment after remediation has taken place. Cost is relayed on a linear foot basis)

Run air scrubber (An air scrubber is designed with a dual filtered system in an arear to eliminate any possible contaminates from going through the home. The air scrubber is ran on a daily based per the whole duration of the job.)

Seal foundations and adjust sprinklers in the backyard to reassure no water enters the crawlspace. (Dig trench for area where water intrusion is occurring. Once the trench is dug there will be a sealant made for foundations. Then once dried the foundation will have the dirt placed back in the trench to cover back the area that was dug out. The sealant will also need to be applied to the inside of the crawlspace. Then the sprinkler in the back will be adjusted to reassure that they don’t spray in the crawl.)

Install new vapor barrier in areas where the water has come in. these areas have hard water deposits which can caution any new buyer from potential leaks or water intrusion. The vapor barrier will be placed on areas that only need it. (Install new vapor barrier in the crawlspace. The vapor is to cover all the dirt to reassure that moisture is kept down. The vapor barrier will be done with a 6mil plastic, which is the industry standard.)