PPE (Personal Protective Equipment) (This is safety equipment for our techs to wear during remediation practices. This is a per person per day basis. There will need to be new PPE every day for proper safety. This includes the Tyvek suits, gloves, and any filters per the duration of the job).
Contain Area for Remediation (Containment eliminates any contaminates from existing into the livable space. Without the containment also the insulation, if removed can possibly enter the livable space, kicking insulation, dirt and possible mold-like substance around. We can pull the containment after remediation has taken place. Cost is relayed on a linear foot basis)
Run air scrubber (An air scrubber is designed with a dual filtered system in an arear to eliminate any possible contaminates from going through the home. The air scrubber is ran on a daily based per the whole duration of the job.)
HEPA vacuuming (This is a pre and post process. HEPA vacuuming is a process of pulling all contaminates off a surface area. This process eliminates mold particles from a surface area with specific vacuums without contaminating the air quality of a livable space. HEPA vacuuming is normally done before and after to reassure no particles are in the space that was contaminated).
Treatment of all areas of contamination with anti-microbial solution (Treatment is performed with an anti-microbial solution that eliminates and prevents future growth. All treatment is warrantied for 3yrs. unless Boise Mold Removal does not provide a warranty under the stipulations of the client not solving the underlying issue that caused the growth in the first place.)
(Removal of Drywall and Baseboard)
Remove 4×10 piece of drywall on living room wall to expose lumber that needs to be treated.
Remove drywall in closet that took on water
Removal of bottom plate of framing to remove subfloor that has been structurally compromised (this will need to have bracing on the wall to ensure this wall is not a load bearing wall)
removal of approximately 6×8 piece of sub flooring that is currently underneath the wall
removal of shelving in closet where drywall will be removed
Extract water out of crawlspace where plumbing line was leaking
Removal of Vapor barrier/ insulation where water is located
Add drying equipment (An air mover is designed to dry out areas where moisture has occurred. The equipment will run the duration of the job until the moisture content has hit the IICRC’s standards for an acceptable level. This is a bigger unit and is charged on a per day basis)
place dehumidifier in crawlspace to ensure moisture is gone
Removal of remaining carpet and tact strip that got wet
install new subfloor where previous had been removed
Rebuild framing and the wall that took on moisture
replace drywall in areas that previous drywall got wet(includes tape, mudding , texture , and paint match
reinstall shelving in closet
Reinstall carpet, tack strip and pad
Install new insulation and Vapor barrier in crawlspace
Please take a chance to review your estimate and click accept. For payments over $1000.00, we require 50% of the payment. The price is subject to change if scope of work increases.
We expect payments upon the completion of the job. There will be a 3% interest charge per month on late invoices.
Status changed: Draft to Pending.
Estimate viewed by for the first time.